operating instruction of square wave controller

Function description:
1. Soft/Hard start slection, when two grey wires are inserted with each other, it is hard start. when separated, it is soft start.
2. Meters, the green wire with bullet plug is connected with phase meter, the other with white socket is connected with hall meter.
3. Manual cruise, means after you press the cruise button on the e-vehicle handlebar, then it runs at a uniform motion status with the existing speed,untill press the button again.
4. 3 speed,
5. High voltage brake, when the brake signal comes from postive power, controller stops working.
6. High voltage brake, when the brake signal comes from negative power, controller stops working.
7. Neutral reversing, when brown and black wires connect together, vehicle will reverse. when grey and black wire connetc together, controller stops working.
8. Anti-thief, red and black wires should be connected with the power of alertor. orange, blue and brown wires should be connected with the signal wires of alertor.
9. Throttle wire, red wire connects to postive power of throttle (about +4.3v), green wire connetcs to signal wire of throttle, black wire connects to negative power of throttle (earth wire).
10. Hall wire, red wire connects to postive power of hall, black wire connects to negative power of hall, yellow green and blue wires connetc to signal wires of hall.
11. Phase wire, yellow green and blue wires connect with motor phase wires correspondingly.
12. Power wire, red wire connects to postive power of battey, black wire connects to negative power of battey.
Install Instruction
1.Power off→Lift the vehicle on blocks to get the drive wheels off the ground before testing→Connect three wires, positive pole thick red wire, negative pole thick black wire and power switch thin red wire. Three thick wires from the controllers yellow, green and blue match with the same colors from the Unite motor. Five thin hall wires connect to the motor. Last, connect three throttle wires, red, green and black.
2. Switch on and start the throttle slowly. Listen and watch if it can run smoothly. Stop if you hear abnormal voice. Under such circumstance, three phase wires of the motors or hall wires need to be exchanged (The following diagram for reference).After running smoothly, connect other function wires as requirement. Wrap up other unnecessary wires. Finally, fix the controller and accomplish the installation.
3. Diagram
Left is controller wire and right is motor wire

If the motor reverses, pls adjust the sequence: First exchange two of the three controller hall wires (yellow, green and blue). Then adjust as per the following diagram.
Left is controller wire and right is motor wire